PRODUCT OPERATING MANUAL AND FIGURES

PRODUCT OPERATING MANUAL AND FIGURES;
Before application this product, please read this manual completely.
We would like to emphasize the points you shall pay attention one more time before the application;
Do not cut or soften nails causing the pain, leave it as is. After soaking your foot in warm water for 5-10 minutes, you can apply.
The mostly overcurved nails can be closed by a balsam till 24 hours and so after the nail softens a little, the application can be made however this process shall be described and/or applied by health personnel.
Do not attempt to put the hooks at the sides of the nail.

Certainly insert the hooks on the tip of nail, gently pull it backwards.
Hold the hook not straight but parallel to the nail and apply.
Let the hooks edges compass the nails edges and leave it parallel to the nail
Pull the hook backwards as far as it goes
Stop when you feel pain
After undergo both of the hooks at the both sides of the nail, stretch the tails in the middle and put it in the edges, tails shall be stretched.
If the nail is thin, stretch the tails slightly, not stretch more or cut the nail.

IN ORDER NOT TO CUT THE THIN NAILS, STRETCH THE TAILS NOT STRONGLY BUT SLIGHTLY

If your nails gauge is normal or more, stretch the tails as far as you can and application more than one coat tightly.

So that the brace do not irritate the skin at nail edges, apply the plaster carefully between the skin and tail.
Not dry the plaster when it gets wet let them for drying
If there are infection findings such as swelling, redness over the nail, certainly consult a doctor.
If there is cyst or afflux over the nail, you should consult health personnel for the application.

The application is simple and practical.



APPLICATION;
The product you purchased is manufactured so as to pull the nail up by grasping it at both sides.

  1. Subungual and nails sides cleaning

Before affixing the brace, you can clean Subungual and nails sides. For this purpose, clean the dirt and wastes off under the nail and its sides via a blunt buffer. Not cut the nail at one or both side.
Firstly soften the debris under the nail by keeping your foot in warm water for 10 minutes. Then clean with buffer.
Our purpose is to open an appropriate hole under the nail for entry of the brace.
Now, you are ready for application. Firstly, examine the application figures. Then read carefully the explanations written below. If there is something not understood, please visit the following websites www.ingrownnail.org or www.tirnakbatmasi.org and so you can examine the application examples.

  1. Affixing braces

Hold the nail brace from the white colored plastic handle side. You can understand the handles from the grey circles on them. Seize on the plastic handle so as not to move the brace. Our purpose is to affix both of the braces at both sides of nail by seizing them at the handles.
While applying this, hold the hook parallel to the nail, start affixing it from the top of nail and carry it backwards. CERTAINLY do not try to affix it by pushing sideward. (Figure 1).
After affixing the braces separately at the both sides, you can pull them backwards without pain as far as you can. (Figure 2,3,4).
At this point, you can select one of two ways;

  1. Firstly, remove the handles from the circles (see 4. Removing the handles) then affix it by passing the punched tires through the notch at the back of the opposite circle or;
  2. Firstly, affix it by passing the punched tires through the notches at the back of the opposite circle then remove the handles (see 4. Removing the handles).
  1. Affixing the punched tires

For both cases, stretch separately the bunched tires coming from the both sides by hand and pass the appropriate hole through the notch which you can touch, at the back of the opposite circle.
Do the same process for the other side.
While doing this, arrange the strain of the tires by pulling at sides like belt so as to nor being loose or squeeze more.
If you want to increase the tires strain once a week, you can stretch it by passing it through the previous hole after removing the tire from the jut.
Or, if you feel more pain or strain from the sides on your nail after the application, you can affix the tire by loosening it in a hole.
For patient having THIN nails, do not strain the nail. Your nail can be cut involuntarily.
For the thick and overcurved nails, you can apply one more braces to the SAME NAIL. You can increase their strain gradually. If necessary, you can increase the power more by applying also Oniko Extra Sarmal on the top.

 

  1. Removing the handles,

According to your estimation, after passing the punched tires through the notches or as soon as affixing the hooks to both nails, you shall remove the plastic handles.
Remove the grey colored plastic plasters by pulling upwards, for this. Afterwards, remove the free plastic string slowly from the ring by pulling it.
If it is not removed simply by this way, you can remove the plastic string by cutting with scissors at the middle.
WARNING: Do not cut the punched tire strip.
As seen from the figure 5, you can cut the residue punched tires from the sides (thin nails). However, if your nails are normal or thick, you can pass the tires through again the notches by winding round the tires one more.
The final view shall be like a belt fastened both sides as seen from the figure 8.
In order not to fall the braces you applied and in order not to give harm to the adjacent skin by the braces, please close braces via 1-2 coat plaster.
For this purpose, apply the plaster on the braces and under the skin, in short between the brace and skin.
At the end of this, the braces will be seen as the figure 9.
Do not rub the plaster after it gets wet or washes. Wait for drying itself. Otherwise, the braces can come loose, fall.
This product is used only for the first nail of human foot. If it affixes to the other nails, certainly consult a health personnel or doctor.
Keep out of reach of children.
Not swallowed, taken mouth.
Elder, fat persons with sight problems may not apply themselves. It is suitable for them to demand help from a family member, relatives or a health personnel.
PAIN OVER THE NAIL SHALL BE GOTTEN LIGHTER WITHIN A FEW HOURS AFTER THE APPLICATION: IF PAIN IS NOT GOTTEN LIGHTER OR STRONGER, REMOVE THE BRACES AND GO TO NEAREST HEALTH CENTER.

 

APPLICATION DURATION;

Thin nails, for children; remove the brace you applied without stretching lot, after a few days or weeks, try to walk normally. If you do not feel pain, do not use the brace no more.
If there is a quick recover but the onyxis repeats, Oniko protective solution* may be prevent its repeat.

* PATIENTS HAVING THIN OR NORMAL NAILS; AND REPEAT ONYXIS, CAN PREVENT THE RECURRENCE BY APPLYING A DRYING LOTION ONCE A DAY ON THE SIDES OF NAILS AFTER THE BRACE APPLICATION IS COMPLETED*.

 

* If Oniko preventive solution* is not found, the solution having drying feature, can be efficient in this group patient.

 

Normal Nails; If your nail is hurt because it cuts, apply the brace for a few weeks till the side grows.

If there is no cut on the nail side, remove the brace after a few weeks and walk without brace, we suggest to use the brace 2-4 weeks more when your pain stops, then remove it.

However do not forget to apply plaster on the hooks in order not to harm skin where the brace touches onf each application.

Plaster shall be applied so as to place on the brace and under the skin, in short between the skin and brace. Plaster prevents the skin from hurting by closing the brace. In this way, if you want, you can apply extra plaster over the brace so as to close the skin after one or two thin coat plaster is applied.

* PATIENTS HAVING THIN OR NORMAL NAILS; AND REPEAT ONYXIS, CAN PREVENT THE RECURRENCE BY APPLYING A DRYING LOTION ONCE A DAY ON THE SIDES OF NAILS AFTER THE BRACE APPLICATION IS COMPLETED*.

* If Oniko preventive solution* is not found, the solution having drying feature, can be efficient in this group patient.

Thick nails; The application duration is changed depending on onyxis duration and overcurved status of nail. For this kind of nails, applying extra sarmal over the brace can be increase the efficiency and shorten the duration of the application.

For the nails having onyxis for a short time (at least 1 year or less) and slightly overcurved, the brace shall be used for 4-6 months. Or, every month, the brace shall be removed and walked without it and if there is no pain, the treatment can be stopped after extra 4 month-application of the brace but there is a repeat onyxis, the next application shall take longer.

For the nails having onyxis for a long time, thick and overcurved and drawing C figure, the brace can be used for 6-8 months. Or, the brace can be removed and walked without it and if there is no pain, the treatment can be stopped after extra 4 month-application of the brace. But repeating the application might be necessary for this kind of patients.

The thick and overcurved and having onyxis for a long time nails repeat the complaints, the patients having this kind of nails have to affix the brace more than one.

By affixing the brace a few times each year, it is possible to pass the remaining duration without trouble, or to renew the application if the problem repeats. You can use the same product more than one period after removing, cleaning, affixing its handles again the small rings. As long as the tires do not break off, the brace will be used.
The searches show this application periods have a certain, permanent effect. So at the end of a few of successive application periods, long term permanent effect can be expected.
Disfiguration, turning inwards of the nails do not require the brace application. If you have not pain, it is not necessary to apply brace. You can solve the problem by cutting nails straight, as square shape and a little long.
By avoiding from the shoes not fit and if you have not pain, it is not necessary to apply the brace. If your pain repeats, you can apply the brace application again.

 

 

 


Sayfamızın görüntülenme sayısı: 215179